1. In the RNC switches, the attempted and successful signaling measurement points are: Relocation Required and Iu Release Command.

2. Which of the following is not the principle of general urban selection?

3. There are two definitions of the number of PDP live requests, which are:

4. When the UE is in IDLE, CELL_FACH, CELL_PCH, the system paging uses paging type 1.

5. In the inter-frequency hard handover, which of the following measurement events is used to initiate the UE measurement?

6. Which of the following does System simulation include? (Multiple choice)

7. In the TD-SCDMA system, which of the following code channel of TS0 does the PCCPCH fixedly configure? (Multiple Choice)

8. The downlink coverage meets the requirement, which means that the pilot powers PCCPCH RSCP and CI received by the terminal meet the requirements of the indicator at the same time.

9. Coverage reflects the availability of the network. Which of the following can reflect the network coverage? (Multiple Choice)

10. Which of the following description is correct about the switch trilogy and its sequence?

11. CS dropped call rate = CS service dropped calls times/CS connected times * 100%.

12. When the TD-SCDMA base station requires a feeder length greater than 50m, which feeder will be selected?

13. The actual setup time of video calls is often long. If the time spent in the process of establishing a videophone call is calculated from Dingli and other drive test software signaling, what are the initial signaling and the end signaling?

14. The number of times the RAB assignment request is reflected in the signaling as _______.

15. The downlink synchronization code must be beamformed to cover further.

16. All UMTS-compliant core network providers can be TD-SCDMA core network providers.

17. Which of the following physical channels are used in the uplink synchronization process of the TD-SCDMA system? (Multiple Choice)

18. How many chips between DwPTS (downlink pilot time slot) and T52 of the same subframe?

19. PICH is a channel generated by the physical layer and does not carry any transmission channel information.

20. The number of uplink synchronization codes corresponding to UEs of different ASCs (access service levels) is fixed. Therefore, the probability of uplink synchronization code collision codes when multiple UEs are simultaneously accessed can be reduced by defining ASC.