Read H35-581_V2.0-ENU Free Demo Questions – Verify the HCIP-5G-RNP&RNO V2.0 Certification Exam Questions

Obtaining the HCIP-5G-RNP&RNO certification to prove your skills and enhance your career is highly recommended. When planning to earn this certification, you must register for the H35-581_V2.0-ENU exam and achieve success. HCDAtest has the latest Huawei H35-581_V2.0-ENU exam questions for your learning.

To ensure your success and obtain the desired HCIP-5G-RNP&RNO V2.0 certification, it is essential to have the necessary study materials and resources. HCDAtest has recently launched the highly anticipated HCIP-5G-RNP&RNO V2.0 H35-581_V2.0-ENU exam questions, which comprehensively cover all the exam objectives. By utilizing these HCIP-5G-RNP&RNO V2.0 questions and answers, you will gain access to a wealth of knowledge and information that will greatly enhance your exam preparation. With the assistance of HCDAtest, you can confidently approach the exam and increase your chances of passing with outstanding results. Free demo questions for the H35-581_V2.0-ENU exam are available online for you to check.

Begin to Test:

1. Under the Option3x architecture, during the dual connection establishment process, the eNB will send an ERAB Modify IND message to the MME. Which network element does the IP address carried in the message belong to?

eNB

gNB

SGW

Question 1 of 33

2. Regarding the SgNB release process under EN-DC, which of the following statements is wrong?

The processes of normal release and abnormal release are basically the same.

Divided into two scenarios: MENB triggering and SGNB triggering

If the abnormal release is triggered by MENB, it must be a 4G problem.

If the abnormal release is triggered by MENB, it may be a problem on the 5G side.

Question 2 of 33

3. Regarding the description of the SSB physical cycle, which of the following descriptions is wrong?

The physical cycle can be flexibly configured

Send all SSB beams in a scanning manner in each cycle

The smaller the period, the faster the UE searches for cells.

The larger the period, the faster the UE searches for cells.

Question 3 of 33

4. Regarding the switching mechanism of BWP, which of the following descriptions is wrong?

The uplink and downlink of the TDD system must be switched at the same time

The handover can be triggered by the base station or the terminal.

The uplink and downlink of the FDD system can be switched independently

Handover can only be triggered by the base station

Question 4 of 33

5. Regarding SSB measurement, which of the following descriptions is correct?

Mainly used for CSI reporting measurements

Views primarily used for mobility management

As long as the center frequency of SSB is the same, it is the same frequency measurement.

Only the central collar point of SSB is different, which means the measurement is different.

Question 5 of 33

6. Which of the following is not the possible bandwidth of CORESETO?

24RB

48RB

96RB

192RB

Question 6 of 33

7. In the inter-frequency switching scenario based on frequency priority, which of the following event measurement reports is used to trigger inter-frequency measurement?

Question 7 of 33

8. If SRS does not support independent power control, then the power control command of SRS is the same as which of the following channels?

PRACH

PUCCH

PUSCH

DMRS

Question 8 of 33

9. Which of the following is the first step in the downlink beamforming process?

Channel calibration

Weight calculation

Weighting

Styling

Question 9 of 33

10. In the PDCCH CCE aggregation level adjustment algorithm, which of the following parameters does gNB use as input?

CQI Report

PHR report

MR report

SRS measures SINR

Question 10 of 33

11. After NSA high load protection is turned on, which of the following option descriptions is correct?

Reduce the scheduling priority of NSA UE Non-GBR services

Reduce the scheduling priority of NSAUEGBR services

Reduce the scheduling priority of ordinary 4GUE Non-GBR services

Reduce the scheduling priority of ordinary 4GUE GBR services

Question 11 of 33

12. Which of the following KPI indicators cannot be counted based on the community?

RRC establishment success rate

Switching success rate

PRB utilization rate

CPU utilization

Question 12 of 33

13. In the NSA networking scenario, which of the following neighbor cells does not require planning?

Neighboring cells between 4G cells

Neighboring cells between 5G cells

Neighboring cells between 4G and 5G cells

Neighboring cells between 5G and 4G cells

Question 13 of 33

14. Regarding 5G DRX parameter configuration, which description is wrong?

The larger the DRX cycle, the better the UE power saving performance.

On duration timer starts immediately when the UE enters the DRX cycle

The larger the short DRX cycle timer is, the worse the UE power saving performance will be.

The smaller the DRX Inactive timer, the better the UE power saving performance.

Question 14 of 33

15. In Huawei base stations, what is the minimum aggregation level of PDCCH CCE?

1CCE

2CCE

4CCE

8CCE

Question 15 of 33

16. How many bits are the uplink power control commands in 5G?

1bit

2bit

3bit

4bit

Question 16 of 33

17. In CA, SCELL changes are triggered by which of the following events?

Question 17 of 33

18. In Huawei gNB, which protocol layer is the traffic statistics indicator based on?

PDCP

RLCO

MACO

PHY

Question 18 of 33

19. If SCG addition based on traffic volume is enabled, which protocol layer's service measurement is used to trigger by eNodeB?

PDCP

RLC

MACG

PHY

Question 19 of 33

20. Which of the following NSA frequency band combinations may have second-order intermodulation interference?

B1+N41

B3+N41

B1+N78

B3+N78

Question 20 of 33

21. Regarding UE access on the 5G side in the NSA scenario, which of the following descriptions is wrong?

UE does not need to make cell selection decision

Prioritize the basic randomly access process

UE scans through sync rasteri to find the location of sSB

The UE directly finds the location of the SSB based on the frequency number of the SSB.

Question 21 of 33

22. In a low-frequency scenario, how does the UE obtain the beam ID of the current SSB?

Obtained through MIB message

PBCH DMRS acquisition

Obtaining through PBCH physical layer coding information

Obtained through SIB1 message

Question 22 of 33

23. Under the Opiton3x architecture, if the SgNB addition process is triggered, a maximum of how many tunnels will be established on the X2-U interface?

Question 23 of 33

24. Which of the following BWPs is at the community level?

InitialBWP

DedicatedBWP

ActiveBWP

DefaultBWP

Question 24 of 33

25. When 4 downlink streams are used, which of the following configuration schemes for PDSCH DMRS has the highest overhead?

type1 preceded by a single symbol

type1 preceded by double symbols

type2 preceded by a single symbol

type2 preceded by double symbols

Question 25 of 33

26. In 100MHz, 30KHz, SCS network, what is the maximum bandwidth of SRS?

270RB

271RB

272RB

273RB

Question 26 of 33

27. Which of the following reference signal positions is related to PCI?

PBCH DMRS

PDSCH DMRS

PDCCH DMRS

CSI-RS

Question 27 of 33

28. In the RRC Inactive state, what is the scope of the UE paging message?

LAC

RAC

TAC

RNA

Question 28 of 33

29. Regarding the description of PDSCH and PUSCH, which of the following descriptions is wrong?

In the time domain, imaging can only be carried out through SLIV.

The area can only be shot through RIV.

In the time domain, it includes two formats: TypeA and TypeB.

All need to include DMRS as relevant demodulation

Question 29 of 33

30. For the public PDCCH space, what is the minimum CCE format?

1CCE

2CCE

4CCE

8CCE

Question 30 of 33

31. What is the maximum number of PRBs contained in 1 RBG?

Question 31 of 33

32. Which of the following formats PUCCH does not have DMRS?

format0

format1

format2

fbrmat3

Question 32 of 33

33. Which of the following is a physical layer processing step unique to the DTF-S-OFDM waveform?

Modulation

Scrambling

Transformer Precoding

Layer mapping

Question 33 of 33

admin Posted in HCIP, HCIP-5G-RNP&RNO H35-581_V2.0, H35-581_V2.0-ENU, H35-581_V2.0-ENU exam questions, H35-581_V2.0-ENU free questions Leave a comment

HCDA Test Preparations

Latest Huawei Exam Dumps | New HCIA, HCIP and HCIE Tests

Read H35-581_V2.0-ENU Free Demo Questions – Verify the HCIP-5G-RNP&RNO V2.0 Certification Exam Questions

Leave a Reply Cancel reply

Recent Posts

Tags